Ellaspede’s Number Plate Reflector Mount fits to the bottom of your number plate to mount your reflector cleanly below the licence plate, a legal requirement for bikes on the road.
- Laser cut from 3mm Aluminium for maximum strength
- Reflector size is 88mm x 38mm E-mark and DOT SAE required size (Minimum legal size)
- The hole spacing is 160mm and the hole length for adjustment is 11mm
- This reflector mount will bolt on to standard Australian plates and selected International plate with no drilling required
- 1 x Number Plate Reflector Mount
- 1 x Reflector
- 2 x M6 x 16 Bolts
- 3 x M6 Nyloc Nuts
- 3 x Washers
Note: Laws may vary from country to country, state to state. Please check with your local transport authority prior to application of this product. Install at your own risk, if in doubt, consult a professional for installation.
Blue Slip rear-reflector requirementBy: Adam on 27 September 2021I needed a rear-reflector for a blue-slip inspection in NSW for a Ducati I recently purchased. The rego was running out within days so after I purchased the item online I requested Ellaspede to express post the reflector, offering extra payment as required. A representative replied back to me within minutes and confirmed the reflector would be express posted that day without additional charge. Reflector arrived the next day and my bike passed the inspection. The size of the reflector fits NSW rego plates perfectly without additional holes required to be drilled - cheers team.
Very good qualityBy: Juan on 30 October 2020Very good quality and build and good price too. And they gave extra sticker too. A++++
Great product!By: Luke on 1 March 2019Nice streamline look, refector only hngs about 2mm lower than my number plate.